Owners manual ryobi bts10s

Page Cutting Tips Cut the wood with the finish side up. See page 24 for information on miter cuts. Mark the board from the point at 6 in. Prepare the saw for ripping as discussed on page Retighten the screw. Wait for the blade to come to a complete stop before removing any part of the workpiece.

Page 24 When the cut is made, turn the saw OFF. Page 25 When the cut is made, turn the saw OFF. Page 26 When the cut is made, turn the saw OFF. Page 27 NOTE: Always use push blocks, push sticks, and featherboards when making non-through cuts to avoid the risk of serious injury.

The Ryobi part number for the dado set is DO NOT perform bevel dado cuts on this machine. SCREW Raise the blade to the maximum height by turning the height adjusting handwheel counterclockwise. Unlock the bevel locking lever. Use of any other parts may create a hazard or cause product damage. Page Troubleshooting 1. Replace or have blade sharpened.

Slow the feed rate. Align the rip fence. Replace wood. Call Ryobi Technical Service at Check and adjust the rip fence. Have blade resharpened. Adjust positive stops.

Be sure to provide all pertinent facts when you call or visit. Please call for your nearest Ryobi Authorized Service Center. You can also check our web site at www. Print page 1 Print document 32 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account?

Sign up! Restore password. Upload manual. Upload from disk. To reduce the risk of injury, the user must read and understand the operator's manual before using. Previous Page. Next Page. Page 2: Table Of Contents The replacement power tool will be covered by the limited warranty for the balance of the two year period from the date of the original purchase.

Use clamps or a vise to hold work when practical. Read and understand all instructions. Keep proper footing and all instructions listed below, may result in electric shock, balance at all times.

Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. This speed is not constant and decreases under a When using a power tool at a considerable distance from the load or with lower voltage.

Table Size No Load Speed Net Weight The blade is adjusted with the blade adjusting handle on the front See Figure 2. Bevel angles are locked with a bevel locking Before attempting to use this product, familiarize yourself lever below the front rail. Upper Side Brace Upper Brace This product requires assembly. Assembly is best done in the area where the saw will be used. Do not lift the saw without help.

The saw base weighs ap- proximately 42 lbs. Hold it close to your body. Keep your knees bent and lift with your legs, not your back. Ignoring these precautions can result in back injury. There are six basic cuts: 1 the cross cut, 2 the rip cut, 3 the miter cut, 4 the bevel cross cut, 5 the bevel rip cut, and 6 the compound bevel miter cut.

All other cuts are combina- tions of these basic six. A featherboard is a device used to help control the workpiece by guiding it securely against the table or rip Completely lower the saw blade. Position the rip fence to the fence. NOTE: The hand closest to the blade should be placed Carefully check all setups and rotate the blade one full on the miter gauge lock knob and the hand farthest from See Figure